"Plateau Structure" for Smooth Sliding Surfaces

The ideal surface for sliding faces to operate smoothly without catching or seizing is known as a "plateau structure." In this profile, the peaks have been shaved flat, leaving only deep valleys behind.
The flat plateau regions stably support contact loads, while the deep valley regions retain lubricating oil—preventing excessive friction, wear, and galling.

Parameters for Preventing Initial Wear and Catching

Rpk (Reduced Peak Height) - Evaluating "Height"

The average height (material volume) of the highest peaks on the surface. High values indicate prominent peaks that contact the mating surface directly, causing initial running-in wear and abrasive debris.

HSC (High Spot Count) - Evaluating "Quantity (Density)"

The number of peaks exceeding a predetermined slicing level (reference threshold). While Rpk measures peak volume and height, HSC quantifies the frequency of potentially damaging peaks.
When peak tops are removed through honing (plateauing), the number of peaks above the threshold drops sharply; thus, as Rpk decreases, HSC drops drastically (or reaches zero).

Parameters for Core Support and Oil Retention

Rk (Core Roughness Depth) - Index of Long-Term Stability

The roughness depth of the central core profile that carries working loads over the component's operational lifespan after initial running-in wear has ended.

Rvk (Reduced Valley Depth) - Higher Means Better Oil Retention

The depth of the deepest valleys on the surface. These valleys serve as micro "oil reservoirs," preventing seizure and scuffing caused by oil-film breakdown.

Plateau Structure Simulator

Flat (HSC approaches zero) Sharp (HSC increases)
Surface Profile (Cross-Section Curve)
HSC (Above Slice Level): 0 pts
Bearing Area Curve (Abbott-Firestone Curve)

AI Surface Condition Diagnosis

Based on current parameters (Rpk, Rvk, HSC), AI analyzes suitability as a sliding surface and estimates the manufacturing process. Click "Run Diagnosis" to begin.